Cyclic Galvanodynamic Pages

The standard cyclic galvanodynamic analysis contains the following pages at startup:

Chart page

The heart of the Cyclic Galvanodynamic analysis. It contains the data plotted as voltage versus log(current).

Experimental Setup page

A list of the parameters used to acquire the data presented on the Chart page.

Experimental Notes
The notes entered by the user before acquiring data. You can edit the Notes in the analysis, and saved with the changes to an analysis data file.

Open Circuit Voltage page

Displays a chart of OCP vs time that was collected during the Initial Delay.

Hardware Settings Page
All of the potentiostat settings used during the experimental run.

NOTE: THE PAGES BELOW ARE NOT PRESENT AT START-UP:

This page contains a grid of integration values based on different sections in visible traces from the most recent use of the Integrate command.

This page contains a grid of minimum and maximum values of each visible trace based on the most recent use of the Min/Max command.

This page contains a grid of corrosion rates, Ecorr, Icorr,, and β information based on the most recent Tafel fit.

This page contains a grid of corrosion rates, Ecorr, Icorr,, and β information based on the most recent Polarization Resistance fit.

This page contains a grid of corrosion rates, and Ecorr information based on the most recent E Log I fit.