The Quick Integrate command is used to integrate the current to achieve a total charge value. This command requires that an x-region be selected. The command operates on all visible… read more →
The Peak Find command causes the computer search a region of data for a localized peak or valley. The algorithm looks for a change in the slope of the specified… read more →
The Peak Baselines command opens a dialog box which allows you to specify what lines are used for baselines on what peaks. In the figure depicted below, there is one… read more →
The Normalize By Scan Rate and Normalize by Square Root of the Scan Rate commands are used to remove the effect of scan-rate in cases where different scan-rates have been… read more →
The Min/Max command is used to find the minimum and maximum values of the data plotted on the y-axis. This command requires use of the Select X Region tool if… read more →
The Integrate command integrates the current to achieve a total charge value. This command requires that you select a portion of a specific curve. The command operates on only the… read more →
The Delta Ep command is used to determine the potential difference between two peaks. In order to use this command, first you must find two or more peaks with the… read more →
The Clear Regions command clears all the regions associated with the chart. Any regions that are shown are removed as well. Any pages associated with region information are removed.
The Clear Peaks command clears all the peaks associated with the chart. Any marked peaks are also removed. Any pages associated with peak information are removed.
The Clear Lines command clears any lines drawn on the chart. This includes Freehand lines, any Linear Fit lines, as well as lines drawn with the Automatic Baseline command. If… read more →