Galvanodynamic Pages

The standard galvanodynamic analysis contains the following pages at startup:

Chart page
The heart of the Galvanodynamic analysis. It contains the data plotted as voltage versus log(current).

Experimental Setup page
A list of the parameters used to acquire the data presented on the Chart page.

Experimental Notes
The notes entered by the user before data-acquisition. You can edit the Notes in the analysis, and saved with the changes to an analysis data file.

Open Circuit Voltage page
Displays a chart of OCP vs time that was collected during the Initial Delay.

Hardware Settings Page
All of the potentiostat settings used during the experimental run.

NOTE: THESE PAGES DO NOT APPEAR AT START-UP:

This page contains a grid of integration values based on different sections in visible traces from the most recent use of the Integrate command.

This page contains a grid of minimum and maximum values of each visible trace based on the most recent use of the Min/Max command.

This page contains a grid of corrosion rates, E_corr, I_corr, and β information based on the most recent Tafel fit.

This page contains a grid of corrosion rates, E_corr, I_corr, and β information based on the most recent Polarization Resistance fit.

This page contains a grid of corrosion rates, and E_corr information based on the most recent E Log I fit.