If your CPT system includes a TDC4 or TDC5 Temperature Controller, it needs to be calibrated before it can be used. Calibration instructions are in the TDC4 or TDC5 Operator’s… read more →
The following figure shows the block diagram for a Critical Pitting Temperature system that uses a TDC Temperature Controller. This figure is the basis of the following discussion. A Gamry… read more →
The Critical Pitting Temperature system includes three techniques that can be used in the study of pitting phenomena. These techniques are highly automated, with the computer completely controlling the data-acquisition… read more →
The Critical Pitting Temperature System is used to determine the temperature-dependence of pitting corrosion. An electrochemical technique measures pitting while the temperature of a metal sample is varied. The pitting… read more →
The final step in the installation is a test that the system has been installed properly. If you have a TDC temperature controller: The following procedure tests a system based… read more →
The Critical Pitting Temperature software outputs a control bit that you can use to turn a stirrer on and off. This stirrer bit is turned on whenever the system is… read more →
The following three GAMRY.INI sections describe three different temperature controllers. [TDC_1] LABEL=TDC2 TYPE=2 PORT=1 MODE=COM1:9600,O,7,1 [TDC_2] LABEL=TDC1 TYPE=1 [TDC_3] LABEL=Bath TYPE=3 PORT=1 MODE=COM4:9600,N,8,1 All three sections came from one GAMRY.INI… read more →
NOTE: The Gamry Framework™ installation program makes the appropriate entries into the GAMRY.INI file. Follow these steps only if you wish to make a change manually. These instructions tell you how… read more →