The Subtract Background From File command lets you subtract one data file from another. This technique is usually used to subtract out information that pertains to the supporting electrolyte rather… read more →
By default, the Echem Analyst™ uses positive signs for current, power, and energy in charge, and negative signs for the corresponding values in discharge. The Sign Options command overrides the… read more →
The Set Current Plot As Default command allows you to save the current settings of a plot as the default. When this is done, all files of the same type… read more →
The Restore System Default Plot command clears any settings that were previously saved via the Set Current Plot As Default command. After you select this command, the chart is refreshed… read more →
The Region Baselines command opens a dialog box which allows you to specify what lines are used for baselines on what regions. In the figure depicted below, there is one… read more →
The Quick Integrate command is used to integrate the current to achieve a total charge value. This command requires that an x-region be selected. The command operates on all visible… read more →
The Peak Find command causes the computer search a region of data for a localized peak or valley. The algorithm looks for a change in the slope of the specified… read more →
The Peak Baselines command opens a dialog box which allows you to specify what lines are used for baselines on what peaks. In the figure depicted below, there is one… read more →
The Normalize By Scan Rate and Normalize by Square Root of the Scan Rate commands are used to remove the effect of scan-rate in cases where different scan-rates have been… read more →
The Min/Max command is used to find the minimum and maximum values of the data plotted on the y-axis. This command requires use of the Select X Region tool if… read more →