The runtime control consist of three buttons and a Curve List pull-down control. The three control buttons are familiar to any user of the single-cell DC Corrosion experiments, although in multiplexed… read more →
Here is the Multiplexed Cyclic Polarization Setup dialog box complete with its default parameters. Pstat, Multiplexer Select your Pstat and Multiplexer using the labeled radio buttons. You may select only… read more →
Run the Multiplexed Galvanic Corrosion standard technique is run by selecting Experiment > Multiplexed DC > Mulitplexed Galvanic Corrosion from the Framework™ menu bar. This initiates the following sequence of… read more →
The following important terms are used throughout this help section. Active Cell The cell (if any) currently connected to the system potentiostat. Any electrochemical measurements are made on the active… read more →
This section describes the standard corrosion-measurement techniques that are included with a Multiplexed DC Corrosion system. All of these techniques use an ECM8 Electrochemical Multiplexer to run sequential tests on… read more →
Run the Multiplexed Corrosion Potential standard technique by selecting Experiment>Multiplexed DC Corrosion>Multiplexed Corrosion Potential from the Framework™ menu bar. This initiates the following sequence of events: 1. The Framework creates… read more →
The Multiplexed Corrosion Potential test outputs one data file for each channel selected during Setup. The data filename includes the multiplexer channel number before the .dat filename extension. The data… read more →