Pstat.SetStability() Type: INSTANCE FUNCTION Purpose: Set the I/E converter stability for potentiostat mode. There are four settings for stability: Fast (0) MediumFast (1) Medium or Normal (2) Slow (3) with… read more →
Pstat.SetThermoSelect() Type: INSTANCE FUNCTION Purpose: Specifies the type of value to be reported when the Auxiliary channel on the control board is set to measure the thermocouple. Usage: ThermoSelectSet =… read more →
Pstat.SetVchFilter() Type: INSTANCE FUNCTION Purpose: Pstat.SetVchFilter() sets the filter on the voltage-measuring channel. This filter has no effect on potentiostat stability. If the parameter passed by SetVchFilter() is a frequency… read more →
Pstat.SetScanRange() Type: INSTANCE FUNCTION Purpose: Set the voltage range of the Scan DAC. When the signal is attached to the potentiostat, the scan range is automatically set. However, if you… read more →
Pstat.SetSenseSpeed() Type: INSTANCE FUNCTION Purpose: Sets which I/E electrometer (Fast or Slow) is used (PCI4 Femtostat Only). Usage: Pstat.SetSenseSpeed(State) State SenseSlow Slow I/E and Electrometer… read more →
Pstat.SetSenseSpeedMode() Type: INSTANCE FUNCTION Purpose: Sets the Sense Speed auto-set mode. NOTE: PCI4 Femtostat ONLY Usage: Pstat.SetSenseSpeed(State) State TRUE Sense Speed automatically selected based on current… read more →
Pstat.SetIERangeMode() Type: INSTANCE FUNCTION Purpose: Enable or disable current-measurement autoranging. If autoranging is enabled (on), after each current measurement is made, the current range is adjusted before the next point… read more →
Pstat.SetIruptMode() Type: INSTANCE FUNCTION Purpose: SetIruptMode() controls current-interrupt IR-compensation. Using this function you can control: Current-interrupt timing Voltage-error calculation mode Feedback mode The current-interrupt feature of the potentiostat uses a… read more →
Pstat.SetLEDS() Type: INSTANCE FUNCTION Purpose: Set the on/off state of the LEDs on a PCI4 family potentiostat. NOTE: This function is for PCI4 family potentiostats only! Individual LEDs can be set,… read more →
Pstat.SetPosFeedEnable() Type: INSTANCE FUNCTION Purpose: Set, then enable state of the Positive Feedback DAC. Positive feedback is enabled when performing positive-feedback IR-compensation. Also make a call to SetPosFeedResistance to set… read more →